OKI MICROLINE 8810 User Manual

No parallel cable is supplied with the printer. Use 

a shielded, bi-directional, IEEE-1284 compatible, 

parallel cable no longer than 6 ft. (1.2 m).

1. Turn off the printer.
2. Connect the parallel cable to the parallel port on 

the printer and secure it with the wire loops.

3. Secure the cable in one of the channels (1) 

molded into the housing on either side at the back 

of the printer to keep it out of the way.

4. Connect the parallel cable to the parallel port on 

the computer and secure it in place with the 

screws.

5. Turn on the printer. 

No Ethernet

®

 cable is supplied with the printer. 

Use an Ethernet cable with two twisted wire pairs 

and an RJ45 plug.

The network print server is 10/100 Base-T Ethernet.
• Frames

– IEEE 802.3 and 802.3
– Ethernet-II
– SNAP
– Auto  Detect

• Network Protocols

– TCP/IP
– IPX/SPX (NetWare)
– NetBEUI

• Functions

– Self-diagnostic
– Banner supported
– Configuration by Web browser
– Notification of printer status by Email

See the on-line User’s Guide on the CD supplied with 

your printer for more information.

1. Turn off the printer.
2. Connect one end of the Ethernet cable to the 10/

100B port on the back of the printer.

3. Connect the other end of the Ethernet cable to 

the network.

F3_03_crop.

jpg

  

F1_24c.jpg

  

parallel_pc.

jpg