Infocus H55SC User Manual
English
11
6. How to install tool
CAUTION:
For tools such as a bull point and a cold chisel,
use only Hitachi genuine parts.
use only Hitachi genuine parts.
(1) Clean, then smear the tool shank with the
grease provided.
(2) Slide the tool holder in the direction of arrow
A and rotate it 180˚.
Turn the notch of the tool shank downward and
insert it fully into the hexagonal hole of the
front cover. (Fig. 2)
Turn the notch of the tool shank downward and
insert it fully into the hexagonal hole of the
front cover. (Fig. 2)
(3) Turn the tool holder and align the front cover
mark with the tool holder mark to secure.
NOTE: Remove in the reverse order to
installation.
HOW TO USE THE DEMOLITION HAMMER
1.
After placing the tip of the tool in the base hole,
switch ON.
switch ON.
2.
By utilizing the empty weight of the machine
and firmly hold the hammer with both hands,
you can effectively control the subsequent
recoil motion. Proceed at a moderate work-
rate, applying too much force will impair
efficiency.
and firmly hold the hammer with both hands,
you can effectively control the subsequent
recoil motion. Proceed at a moderate work-
rate, applying too much force will impair
efficiency.
Fig. 2
Tool holder
Tool shank
Front cover
A
Fig. 3
01Eng_H55SC_US
7/6/07, 10:46
11