Harbor Freight Tools 66187 User Manual

SKU 66187 

Page 2

Park truck in level, stable location well away 

1. 

from traffic.  Place transmission in park/neu-

tral and set parking brake.

Blind Fasteners will need to be installed 

throughout these instructions.  To install:
Slide Flat Washer (B) over 

1. 

Installation Bolt (A).  Place a 

box end wrench over Installa-

tion Nut (C), and thread Instal-

lation Nut into Installation Bolt 

as shown to the right.  Thread 

Installation Nut completely 

onto Installation Bolt.  This as-

sembly is the installation tool.
WarnIng!  Verify that installation surface 

2. 

critical components before drilling.
Drill an 11 mm (0.433”) hole in the location 

3. 

the Blind Fastener will be installed.
Insert Blind Fastener so that the flange rests 

4. 

on the lip of the hole.
Thread Installation Bolt into Blind Fastener 

5. 

as far as possible.  Hold Installation Bolt in 

place with one wrench while turning Installa-

tion Nut (C) clockwise with another wrench 

until Blind Fastener is held securely in place.
Remove Installation Bolt from Blind Fastener.

6. 

note: The Front Rack is near the truck cab.

1. 

Slide Front Mounting Bracket (2) over Front 

Base (4) as shown above.  Temporarily se-

cure in place with Jam Bolt (D).
Place the Base/Bracket assembly as shown 

2. 

below at the passenger side of the vehicle 

near the cab.  Loosen the Jam Bolt and allow 

the Base to slide down so the foot rests flat 

on the truck bed.
Mark the bedrail at center of the holes, 3 

3. 

holes in the side and 1 hole on the truck bed.  

Any one of the 4 holes in the Base can be 

used for the truck bed hole.  Set the assem-

bly aside.
Drill for and install 4 Blind Fasteners (H) in 

4. 

the locations marked in the previous step.

5. 

Attach the assembly to the Blind Fasteners 

as shown above using Bolts (E), Washers 

(F), and Spring Washers (G) - as shown 

above.