Hotpoint he7l 492 User Manual

2. If the floor is not perfectly level, compensate 

for any unevenness by tightening or loosening 

the adjustable front feet (see figure); the an-

gle of inclination, measured according to the 

worktop, must not exceed 2°.

Levelling your appliance correctly will provide 

it with stability and avoid any vibrations, noise 

and shifting during operation. If it is placed on 

a fitted or loose carpet, adjust the feet in such 

a way as to allow enough room for ventilation 

beneath the washing machine.

1. Connect the supply 

pipe by screwing it to 

a cold water tap using 

a 3/4 gas threaded 

connection (see figu-

Before performing the 

connection, allow the 

water to run freely until 

it is perfectly clear.

2. Connect the other 

end of the water inlet 

hose to the washing 

machine, 

screwing it onto the 

appliance’s cold water 

inlet, situated on the 

top right-hand side on 

the rear of the ap-

pliance (see figure).

3. Make sure there are no kinks or bends in the 

hose.

! The water pressure at the tap must be within 

the values indicated in the Technical details 

table (on the page 5).

! If the water inlet hose is not long enough, 

contact a specialist store or an authorised 

serviceman.

! Ensure that the supply taps are allowing wa-

ter through. Old taps may seize in the closed 

position and thus prevent water reaching the 

machine.

! Never use second-hand or old inlet hoses; 

use the products supplied with the machine.

! Keep this instruction manual in a safe place 

for future reference. Should the appliance be 

sold, transferred or moved, make sure the 

instruction manual accompanies the washing 

machine to inform the new owner as to its 

operation and features.

! Read these instructions carefully: they contain 

vital information on installation, use and safety.

! This is a separate 

part of the polystyre-

ne base and should 

be removed with the 

base.

! IMPORTANT check 

when unpacking 

your machine.

1. Unpack the washing 

machine.

2. Check whether the 

washing machine has 

been damaged during 

transport. If this is the 

case, do not install 

it and contact your 

retailer.

3. Remove the 4 pro-

tective screws and the rubber bush with the 

respective spacer, situated on the rear of the 

appliance (see also the installation leaflet).

4. Seal the gaps using the plastic plugs provi-

ded.

5. Keep all the parts: you will need them again 

if the washing machine needs to be moved to 

another location.

! Packaging materials are not children’s toys.

Your machine may 

make a considerable 

amount of noise if the 

two front feet have not 

been adjusted correct-

ly.

1. Install the washing 

machine on a flat sturdy 

floor, without resting it up 

against walls, cabinets 

or anything else.