GE 82-POE User Manual
Chapter 6: Command Line Interface
152
GE-DS-82 and 82-PoE Ethernet Managed Switch User Manual
21 | off | 1
22 | off | 1
25 | off | 1
26 | off | 1
Trk1 | off | 1
Trunk Configuration
Trunk allows the switch to combine ports so that they function like a single high-
speed link. It can be used to increase the bandwidth to some devices to provide a
high-speed link. For example, trunk is useful when making connections between
switches or connecting servers to the switch. Trunk can also provide a redundant link
for fault tolerance. If one link in the trunk failed, the switch can balance the traffic
among the remaining links.
speed link. It can be used to increase the bandwidth to some devices to provide a
high-speed link. For example, trunk is useful when making connections between
switches or connecting servers to the switch. Trunk can also provide a redundant link
for fault tolerance. If one link in the trunk failed, the switch can balance the traffic
among the remaining links.
NOTE:
The 10/100 Mbps port cannot be trunked with gigabit port (port 25-26).
All ports in the same trunk group will be treated as a single port. If a trunk group
exists, the ports belonging to that trunk will be replaced by "TRUNK #" in the VLAN
configuration screen. The following example configures port 25-26 as "TRUNK 1."
exists, the ports belonging to that trunk will be replaced by "TRUNK #" in the VLAN
configuration screen. The following example configures port 25-26 as "TRUNK 1."
Trunking Commands
show trunks
Description:
Show trunking information.
Switch(config)# show trunk
Group ID | LACP | Ports | LACP Active
--------------+--------+-------------------+-----------------
1 | Yes | 23,24 | 23,24