ONKYO BD-SP808 User Manual

•  After connecting to the Internet, set up necessary network settings.
•  Do not insert any cable other than a LAN cable to the ETHERNET terminal to avoid damaging the unit.
•  If your telecommunications equipment (modem, etc.) does not have broadband router functions, connect a 

broadband router.

•  If your telecommunications equipment (modem, etc.) has broadband router functions but there is no vacant port, use a hub.
•  For a broadband router, use a router which supports 10BASE-T / 100BASE-TX.
•  Do not connect your PC directly to the ETHERNET terminal of this unit.
•  For the network setup, refer to “Network Connection” on pages 52-55.
•  For more information about cables or connections, see the manual accompanying modem, broadband router and 

hub you use.

•  Please purchase shielded LAN cables at your local store and use them when you connect to network equipment.

You can use the following multi-room kits to control this unit when it’s out of range of the remote controller:
•  Multiroom kits such as those made by Niles and Xantech.

If another AV component is out of range of its remote controller, you can use a commercially available IR emitter to 
retransmit the remote controller signals received at this unit's IR IN jack, as shown below.

IR IN

IR OUT

Connecting
block

Signal flow

Remote controller

This unit

IR emitter

Other
component

Connect the IR emitter to this unit's IR OUT jack, and place the IR emitter in front of the other AV component's remote 
control sensor (usually located on its front panel), as shown below. See the instructions supplied with the IR emitter.

This unit

from
connecting block

Miniplug cable

IR emitter

IR emitter

Miniplug

Remote control

sensor

Other component

Signal flow

Only remote controller signals received by this unit's IR IN jack are fed through to the IR OUT jack. Signals picked up by 

this unit's remote control sensor are not output.