ONKYO dps-5.5 User Manual

 

45

 

You only need to make this setting if you connected this 
player to an AV receiver (or other component) using one 
of the digital outputs.

 

■

 

If your AV receiver (or other connected component) is 
compatible with MPEG audio, set this to “MPEG”, oth-
erwise set it to “MPEG > PCM” (MPEG audio is con-
verted to more compatible PCM audio). Check the 
manual that came with the other component if you’re 
unsure whether it is MPEG audio compatible.

 

■

 

If you have a widescreen TV, select the “16:9 (Wide)” 
setting—widescreen DVD software is then shown using 
the full screen area. When playing software recorded in 
conventional (4:3) format, the settings on your TV will 
determine how the material is presented—see the man-
ual that came with your TV for details on what options 
are available.
If you have a conventional TV, select either “4:3 (Letter 
Box)” or “4:3 (Pan & Scan)”. In Letter Box mode, wide-
screen software is shown with black bars at the top and 
bottom of the screen. Pan & Scan chops the sides off 
widescreen material to make it fit the 4:3 screen (so even 
though the image looks larger on the screen, you’re actu-
ally seeing less of the picture). See also “Screen sizes 
and disc formats” on page 50. Pan & Scan only works 
with DVD-Video discs that support Pan & Scan.

 

You only need to make this setting if you connected this 
player to a progressive scan compatible TV using the 
component video outputs.

 

■

 

If you have a progressive-scan compatible TV, set this to 
“Progressive” for flicker-free video output. If your TV is 
not compatible with progressive-scan video, set to Inter-
lace.
Check the operating instructions that came with your TV 
if you’re unsure about its compatibility.
• When setting to “Progressive”, you have to press Enter 

once more to confirm. See also below for important 
information on progressive scan video.

 

Compared to interlace video, progressive scan video 
effectively doubles the scanning rate of the picture, 
resulting in a very stable, flicker-free image. Progressive 
scan video is available only from the component video 
output.

 

• Australian model and when TV system is set to 

“AUTO” or “NTSC” only: 

 

 If you want to display video on 

more than one monitor simultaneously, make sure that 
it is set to “Interlace.” See also “Setting the TV sys-
tem” on page 50.

 

•

 

 If you want 

to display video on more than one monitor simulta-
neously, make sure that it is set to “Interlace.” See also 
“Setting the TV system” on page 50.

•

 

 In this case, switch everything off and reconnect 

using the supplied video cable (see “Basic Setup” on 
page 19), then switch back to Interlace. Switch the 
player to standby then, using the front panel controls, 
press

 

 

 

Standby/On while pressing 

 

to switch the 

player back to “Interlace.”

• Australian model and when TV system is set to 

“AUTO” or “NTSC” only: When set to “Progressive”, 
PAL and NTSC discs are both output as progressive 
NTSC video. When TV System is set to “PAL” only: 
Progressive cannot be selected. See page 50.

DPS-5.5_En.book Page 45 Monday, May 17, 2004 4:45 PM