GE s8000 User Manual

Page of 24
Operating Instructions
Safety Instructions
Consumer Support
Tr
oubleshooting T
ips
18
PERFORMANCE (cont.) 
Possible Causes
What To Do
Pilling
Result of normal wear on
• While this is not caused by the washer, you can slow the 
poly-cotton blends and
pilling process by washing garments inside out.
fuzzy fabrics
Snags, holes, tears, rips
Pins, snaps, hooks, sharp
• Fasten snaps, hooks, buttons and zippers.
or excessive wear
buttons, belt buckles,
• Remove loose items like pins, objects in pockets
zippers and sharp objects
and sharp buttons.
left in pockets
• Turn knits (which snag easily) inside out.
Undiluted chlorine bleach
• Check bleach package instructions for proper amount.
• Never add undiluted bleach to wash or allow clothes 
to come in contact with undiluted bleach.
Chemicals like hair bleach
• Rinse items that may have chemicals on them before
or dye, permanent wave
washing.
solution
Wrinkling
Improper sorting
• Avoid mixing heavy items (like work clothes) with 
light items (like blouses).
• Try a fabric softener.
Overloading or
• Load your washer so clothes have enough room 
incorrect water level
to move freely with water covering all of the clothes.
Incorrect wash and
• Match Cycle selection to the type of fabric you are
dry cycles
washing (especially for easy care loads).
Repeated washing in
• Wash in warm or cold water.
water that is too hot
OPERATION 
Possible Causes
What To Do
Washer pauses during 
The HAND WASH or CASUALS
• This is normal. The washer alternates between agitate 
wash cycle
cycle was chosen
and soak during the HAND WASH and CASUALS cycles 
to get your clothes cleaner with less wear.
Washer pauses during
This is normal
• The washer may pause during the spin cycle to remove 
spin cycle
soapy water more efficiently.
Washer won’t operate
Washer is unplugged
• Make sure cord is plugged securely into a working outlet.
Water supply is turned off
• Turn both hot and cold faucets fully on.
Controls are not set properly
• Check controls.
Lid is open–safety feature 
• Close lid and reset cycle, to the beginning if necessary.
prevents agitation and spinning 
when lid is up
Circuit breaker/fuse is
• Check house circuit breakers/fuses. Replace fuses or 
tripped/blown
reset breaker. Washer should have separate outlet.
Electronics need to be reset
• Unplug washer, wait 2 minutes, plug back in, and press 
START.
START was not pressed
• Press START.
Extremely low water pressure
• Press START again.
Before you call for service…