ICOM ic-f43gt-gs

34

6

■ SmarTrunk II™, 

This transceiver is capable of SmarTrunk II™/SmarTrunk
3G™ functions.

The optional UT-105/UT-117/UT-117S allow communications
in conventional channels, SmarTrunk II™/SmarTrunk 3G™
channels. Select a channel bank for SmarTrunk
II™/SmarTrunk 3G™ before trunking operation.

• Push [BANK] several times to select a channel bank for con-

ventional channels or SmarTrunk II™/SmarTrunk 3G™
channels.

- Scanning starts when a channel bank for SmarTrunk II™/

SmarTrunk 3G™ operation is selected.

- Contact your Dealer for channel bank details.

■ SmarTrunk II™ and 

These features are enabled by a Dealer and may not be
available in your system. Contact your Dealer for details.

D Receiving a call

When you hear ringing, push [M] to answer.

• For a group call, you hear a short ring followed by two short beeps.

You do not have to answer a group call to hear it over the air.

D Terminating a call

After completing a call, push [#] to disconnect (hang up).

IMPORTANT: If one person in the conversation terminates
a call, all participants will be cut off.

D Last number re-dial

Push [M] 2times to automatically re-dial the last called num-
ber.

• A high-pitched beep indicates that the number is accepted.

D Clear channel alerting

If all channels are busy, the transceiver automatically begins
searching for an open channel and beeps every ten seconds.
When two short beeps (low-pitched, then high-pitched) are
heard, a channel is available. Push [M], [M] immediately to re-
dial the last number.

IC-F33_43GT_GS_MDC.qxd  06.7.19 2:09 PM  Page 34 (1,1)