ONKYO R-805X User Manual
19
Connecting the 300 ohm ribbon wire:
Connecting the coaxial cable:
1. With your fingernail or a small screw-
1. With your fingernail or a small screw-
driver, press the stoppers outward and
remove the cover.
remove the cover.
2. Remove the transformer wire A from slit
B and insert it into slit C.
3. Prepare the coaxial cable as shown in the
diagram.
Connect the 75/300 ohm antenna
adapter to the coaxial cable.
1 Insert the end of the cable.
2 Clamp it in place with pliers.
Connect the 75/300 ohm antenna
adapter to the coaxial cable.
1 Insert the end of the cable.
2 Clamp it in place with pliers.
4. Re-install the cover.
Do not use the same antenna for both
FM and TV (or VCR) reception since the
FM and TV (or VCR) signals can inter-
fere with each other. If you must use a
common FM/TV (or VCR) antenna, use
a directional linkage type splitter.
FM and TV (or VCR) reception since the
FM and TV (or VCR) signals can inter-
fere with each other. If you must use a
common FM/TV (or VCR) antenna, use
a directional linkage type splitter.
Connecting the antenna cable to the 75/300 ohm antenna adapter (Non-
U.S., Canadian and European models)
U.S., Canadian and European models)
Outdoor
antenna
antenna
Indoor
antenna
antenna
300 ohms
ribbon wire
ribbon wire
Loosen the screws and wrap the wire around
these screws. Then tighten the screws with a
screwdriver.
these screws. Then tighten the screws with a
screwdriver.
Slit C
Slit B
Wire A
1
2
✦ ✦
✦
✦ ✦
✦
✦
✦
✦
✦
✦
6
mm
3
mm
6
mm
15mm
Directional Iinkage
To R-805X
To TV (or VCR)
Directional Iinkage
type splitter
type splitter