highpoint-technologies 2680 User Manual

Rocket RAID 2680 FreeBSD Installation Guide 

- 6 - 

system start up. 

Now you can inform the system to automatically mount the array by modifying the file 

/etc/fstab. E.g. You can add the following line to tell the system to mount /dev/da1s1e to 

location /mnt/hpt after startup: 

        /dev/da1s1e              /mnt/hpt                      ufs        rw      0        0 

To update the driver with a new version you simply reinstall the driver following the previous 

section, “Install the driver on an existing system”. 

HighPoint RAID Management Software is used to configure and keep track of your hard 

disks and RAID arrays attached to RR2680 controller. Installation of the management 

software is optional but recommended. 

To configure HighPoint RAID Management Software to work with RR2680 driver, you 

should setup /etc/hptcfg to be the driver name: 

 

Please refer to HighPoint RAID Management Software documents for more information. 

You can only uninstall the driver when your system is not booting from devices attached to 

RR2680 controller. Just remove the line 

rr2680_load=”YES” 

in /boot/defaults/loader.conf, and then delete the driver module /modules/rr2680.ko or 

/boot/kernel/rr2680.ko .