ONKYO dv-sp502 User Manual

19

Connecting the DV-SP502/DV-SP502E—Continued

The setup described here is a basic setup that allows you to play discs using just the cables supplied with the player. In 
this setup, stereo audio is played through the speakers in your TV.

• This player is equipped with copy protection technol-

ogy. Do not connect this player to your TV via a VCR 
using AV cables, as the picture from this player will 
not appear properly on your TV. (This player may also 
not be compatible with some combination TV/VCRs 
for the same reason; refer to the manufacturer for more 
information.)

PUT ANALOG L/R jacks to a set of A/V inputs 
on your TV.
Use the supplied AV cable (RCA), connecting the 
red and white plugs to the audio outputs and the yel-
low plug to the video output. Make sure you match 
up the left and right audio outputs with their corre-
sponding inputs for correct stereo sound.
See the following page if you want to use a compo-
nent or S Video cable for the video connection.

If you need another pair of stereo outputs (and don’t 
need to use the multichannel analog outputs), you 
can use the FRONT/D.MIX 1 or 2 AUDIO OUTPUT 
jacks (page 22).

Notes:
• Before unplugging the player from the power outlet, 

make sure you first switch it into standby using either 
the front panel STANDBY/ON button, or the remote 
controller, and wait of the “GOOD BYE” message to 
disappear from the player’s display.

• For the above reasons, do not plug this player into a 

switched power supply found on some amplifiers and 
AV receivers.

To power outlet

TV

AV cable 
(Supplied)

Power cord
(Supplied)