Manualsbrain.com
  1. Manuals
  2. Brands
  3. Oricom
  4. eco600
  5. User Manual

Oricom eco600 User Manual

Download
Page of 29
The Answering Machine 
27  
Appendix 
REMOTE ACCESS COMMANDS 
Table 1: Commands at the remote menu  
              Table 2: Commands during message playback 
Key  Function  
Key 
Function 
2 
To play messages 
 
1 
To play previous message 
4 
To play Memo 
 
2 
To repeat current message 
5 
To stop an operation 
 
3 
To play next message 
6 
To play OGM 
 
5 
To stop message playback 
7 
To record Memo 
 
0 
To delete current message 
8 
To switch the answering machine 
on/off 
 
 
 
9 To 
record 
OGM 
 
   
0 
Press twice to delete all old messages 
 
 
 
 
Troubleshooting 
Problem(s) 
Tip(s) 
No dial tone 
•  Check your phone connections. 
•  The handset may be out of range. Move closer to the base. 
•  The battery capacity may be low. Charge battery. 
Signal icon flashing 
•  The handset may be out of range. Move closer to the base.  
•  If the handset displays 
UNREGISTERED
, register the handset. See page 
20. 
Registration fails 
continuously 
•  Your base memory may be full. Delete any un-used handsets and try again. 
See page 21. 
No parking tone 
•  The handset may not be placed properly on the cradle. Try again. 
•  Charging contacts may be dirty. Disconnect the power supply first and then 
clean contacts with a damp cloth. 
•  Turn on the handset tone. See page 18. 
Handset on the charger 
does not charge 
•  The batteries may be defective. Purchase new batteries from your dealer. 
•  Check that the batteries are inserted correctly. 
•  Make sure the handset is placed properly on the charger. The battery icon 
animates while charging. 
No display 
•  Check that the batteries are charged. 
•  Check the power and phone connections. 
Bad audio (crackles, 
echo, etc.) 
•  If you have Broadband installed you MUST install high quality line filters (not 
supplied) on all phone sockets. This is not a problem with your phone.  
•  The handset may be nearly out of range. Move closer to the base unit. 
•  The phone may be interfered by nearby electrical appliances. Move the base 
unit. 
•  The phone may be at a location with thick walls. Move the base unit. 
Handset does not ring 
•  Check that the handset ringer is turned on. See page 18. 
Caller ID does not 
display number 
•  Caller ID service may not be activated. Check with your service provider. 
•  The caller’s information may be withheld or is unavailable. 
Cannot make/answer a 
2nd call 
•  2nd call service may not be activated. Check with your service provider. 
•  Check that the recall selection is correct. See page 19. 
•  Check that the correct country has been selected. See page 9.