Sennheiser EK 2000-CW User Manual
31
Synchronizing a transmitter with the receiver
OR:
왘
Manually set the transmitter to the same frequency bank and channel
that you set on the receiver.
that you set on the receiver.
왘
Activate the RF signal on this transmitter.
The transmission link is established.
The transmission link is established.
If you want to set up a multi-channel system:
왘
Repeat the following 4 steps for each additional transmission link:
– Perform a frequency preset scan with the next diversity receiver.
– Select a channel from the same frequency bank as with the first
diversity receiver.
– Synchronize a transmitter with the diversity receiver.
– Activate the RF signal on the transmitter.
Using freely selectable receiving frequencies
You can also freely select the receiving frequencies and store these
frequencies in the frequency banks “
frequencies in the frequency banks “
U1
” to “
U6
”.
왘
Set each diversity receiver to the same frequency bank (“
U1
” to “
U6
”).
왘
On one of the receivers, select a channel within this frequency bank and
assign this channel a receiving frequency (see page 25).
assign this channel a receiving frequency (see page 25).
왘
Synchronize a transmitter with this receiver (see the instruction
manual of the transmitter).
manual of the transmitter).
OR:
왘
Manually set the transmitter to the same frequency bank and channel
that you set on the receiver.
that you set on the receiver.
왘
Repeat for the remaining transmitters and receivers as described
above.
above.
It might be that the freely selected frequencies are not inter-
modulation-free
modulation-free
If you are using frequencies from the frequency banks “
U1
” to
“
U6
”, it might be that the receiving frequencies are not intermod-
ulation-free.
왘
Contact your Sennheiser partner who will be pleased to
calculate intermodulation-free frequencies for you (see
www.sennheiser.com).
calculate intermodulation-free frequencies for you (see
www.sennheiser.com).