Crestron cnxenet plus User Manual
Crestron CNXENET+
CNX Enhanced Ethernet Expansion Card
9. As shown below, align the pins on the 26-pin DPA connector of the
CNXENET+ with the ETHERNET connector on control system
processor board.
processor board.
CNMSX Installation (3 of 3)
26-PIN DPA
CONNECTOR
9
MOUNTING
BRACKETS
REAR PANEL
(REFERENCE ONLY)
NOTE: The DPA pins are more easily inserted by gently “rocking” the
CNXENET+ side-to-side while pressing onto DPA connector.
CNXENET+ side-to-side while pressing onto DPA connector.
10. DO NOT force pins into connector and press CNXENET+ until pins
are fully seated. Make sure that the mounting brackets on CNXENET+
align with mounting holes of the control system. Make sure that the
LAN/DPA connector aligns with cut out.
align with mounting holes of the control system. Make sure that the
LAN/DPA connector aligns with cut out.
11. From the control system rear panel, reinstall the two screws and
lock washers to secure CNXENET+ . Tighten the screws to
finger-tight then, using a #1 Phillips tip screwdriver, tighten the screws
an additional 1/8-turn.
finger-tight then, using a #1 Phillips tip screwdriver, tighten the screws
an additional 1/8-turn.
12. Reposition the I/O printed circuit board connectors into the rear
panel slots and reinstall six screws to secure I/O printed circuit
board . Tighten the screws to finger-tight then, using a #2 Phillips
tip screwdriver tighten the screws an additional 1/8-turn.
board . Tighten the screws to finger-tight then, using a #2 Phillips
tip screwdriver tighten the screws an additional 1/8-turn.
13. Reinstall the control system top cover with six screws on each
side and four screws on top. Tighten the screws to finger-tight then,
tighten the screws an additional 1/8-turn.
tighten the screws an additional 1/8-turn.
Installation onto CNRACKX Processor Card
(CNXCPU)
(CNXCPU)
The CNRACKX contains the CNXCPU Processor Card (the CNRACKX-DP
contains two CNXCPU’s) that features Crestron’s exclusive DPA (Direct Processor
Access) slot for Ethernet/LAN expansion of the control system. The CNXCPU
contains card mounting points, a LAN/DPA port opening, and a 26-pin female DPA
connector. The CNXENET+ is mounted to the faceplate of the CNXCPU and a
contains two CNXCPU’s) that features Crestron’s exclusive DPA (Direct Processor
Access) slot for Ethernet/LAN expansion of the control system. The CNXCPU
contains card mounting points, a LAN/DPA port opening, and a 26-pin female DPA
connector. The CNXENET+ is mounted to the faceplate of the CNXCPU and a
Operations & Installation Guide – DOC. 8153A
CNX Enhanced Ethernet Expansion Card: CNXENET+
• 5