Kenwood cm176-cm70170 english only User Manual

Page of 2
6 Don’t remove the jug until brewing
has finished. The hotplate will keep
your coffee hot, but the sooner you
drink it, the better it will taste.
7 When the jug’s empty, switch off
by pressing the on/off switch. Let
the machine cool down before
cleaning.
If you haven’t used the machine for
a while, run one lot of water
through it (without coffee) to clean
it out. Fill the tank to the top cup
mark when you do this.
Never put the jug in the
microwave.
care & cleaning
Always switch off and unplug
before cleaning.
Never put the machine in water or
let the cord or plug get wet.
Don’t wash parts in the
dishwasher.
jug, lid
Wash, then dry.
permanent filter
Wash, then dry.
filter door
remove it: open and lift off. Wash
then dry.
body
Wipe with a damp cloth, then dry.
Don’t use abrasives - they’ll
scratch the plastic.
descaling
You’ll know when limescale has
built up because your coffee will
take longer to come through.
When this happens it’s time to
descale.
to descale
1 Buy a suitable descaler.
2 Descale the machine.
3 After descaling, run several lots of
water through the machine to
clean it out. Fill the tank to the top
cup mark when you do this.
4 Wash the parts.
service
If the cord is damaged it must, for
safety reasons, be replaced by
Kenwood or an authorised
Kenwood repairer.
UK
If you need help with:
using your machine or
servicing, spare parts or repairs (in
or out of guarantee)
 call Kenwood customer care  on
023 92392333Have your
model number ready 
- it’s on
the underside of the coffee maker.
Eire
See our advertisement in Golden
Pages.
other countries
Contact the shop where you
bought your machine.
guarantee
If your coffee maker goes wrong
within one year from the date you
bought it, we will repair it (or
replace it if necessary) free of
charge provided:
you have not misused, neglected
or damaged it;
it has not been modified (unless by
Kenwood);
it is not second-hand;
it has not been used commercially;
you have not fitted a plug
incorrectly; and
you supply your receipt to
show when you bought it.
This guarantee does not affect
your statutory rights.
safety
Watch out for steam, never lift the
tank lid during the brewing cycle
or touch the hotplate.
Keep children away from the
machine. And never let the cord
hang down where a child could
grab it. Push excess cord inside
the back of the machine (CM170
series only).
Never use a damaged machine.
Get it checked or repaired: see
‘service’.
Never put the machine in water or
let the cord or plug get wet - you
could get an electric shock.
Unplug:
before filling with water
before cleaning
after use.
Never leave the machine on
unattended.
Don’t let the cord touch hot parts.
Don’t let infirm people use the
machine without supervision.
Don’t let children play with this
machine.
Only use the machine for its
intended domestic use.
Always make sure there is water in
the tank before switching on.
before plugging in
Make sure your electricity supply is
the same as the one shown on the
underside of your machine.
Important (UK) only
The wires in the cord are coloured
as follows:
Green and Yellow = Earth
Blue = Neutral
Brown = Live.
This machine complies with
European Economic Community
Directive 89/336/EEC.
before using for the first
time
1 Remove all packaging.
2 Wash the parts: see ‘care and
cleaning’.
3 Push excess cord inside the back
of the machine (CM170 series
only).
4 Run two lots of water through the
machine (without coffee) to clean it
out. Fill the tank to the top cup
mark when you do this. See ‘to
make coffee’.
key
 filter door
 permanent coffee filter (or use a
paper filter instead)
 water tank
 compartment for excess cord
(CM170 series only).
 on/off switch with indicator light
 measuring spoon
 jug
 hotplate
to make coffee
1 Pour water into the tank. The
water must be between the top
and bottom cup marks. Then close
the lid.
Use cold water. We recommend
using filtered water from a
Kenwood Water Filter as it reduces
limescale. Never use warm or fizzy
water.
If you use the jug to fill the tank,
look at the tank marks, not the jug
marks. They’re slightly different to
allow for the fact that some of the
water gets absorbed by the coffee.
2 Open the filter door.
3 Add either a permanent filter or a
paper filter. Add the coffee, use
the spoon provided (approximately
1 level spoon per large cup). Then
close the filter door.
4 Put the jug on the hotplate.
5 Plug in and switch on, the light will
glow.