Honeywell equip hd3mdih User Manual

38

Installing the Honeywell IP Utility and Web-Client Software

Your HD3MDIH/X camera supports the PSIA specification for interoperability between 
network video products. There is no support for legacy EQUIP and EQUIP2 protocols. 

For further information, refer to the documentation supplied with your NVR or contact your 
NVR network administrator. 

Only one user, an Administrator or a Guest, can log on to the Web-Client 
application at one time. After you are logged on as an Administrator, there is 
no time out until you click Logout. To allow other Administrators to log on, 
you must log out when the session is done. 

After the IP Utility software is installed for the first time, you can change the 
Administrator or Guest passwords and upgrade firmware. 

It is important to click Apply in order to save any configuration change.

1. Log onto the Web-Client. There are two ways to launch the Web-Client and log on— 

via the Honeywell IP Utility Program or directly from Internet Explorer.
Honeywell IP Utility 
a. Log onto the Honeywell IP Utility program.
b. From the Discovery pane, click to select the device to launch its browser. 
c.

To enable or disable the HTTP server, select or clear the Enable HTTP Server 
check box. By default, the HTTP server is enabled.

d. From the System tab, click Launch Browser. 

The Web-Client application for the selected device opens in Internet Explorer.

Internet Explorer
From Internet Explorer (v6.0+), enter the URL (IP address of the device) in the 
Address bar to open the logon window.

2. Select a User Name and enter a Password.

a. From the User Name drop-down list, select Administrator or Guest.