Honeywell equip hd3mdih User Manual
Document 800-07361 Rev A
73
12/10
D
Glossary
AGC (Automatic Gain Control)
Video Amplifier in a camera that boosts the amount of
video gain (including the noise) to maintain a 1V p-p (1-volt peak-to-peak) video signal
output. It becomes operational when the light level is low. The circuit is designed to
compensate for fluctuations in scene illumination which would cause the video output
level to be too low. If the video level (scene illumination) is adequate, the circuit does not
apply any gain to the signal. As the video level falls, more gain is applied by the AGC
circuit to the video signal.
output. It becomes operational when the light level is low. The circuit is designed to
compensate for fluctuations in scene illumination which would cause the video output
level to be too low. If the video level (scene illumination) is adequate, the circuit does not
apply any gain to the signal. As the video level falls, more gain is applied by the AGC
circuit to the video signal.
ALC (Automatic Light Compensation)
Setting in an Auto Iris lens to control the iris
opening. Adjusts between peak and average to respond to the bright part of the scene
(peak setting) or the average value of the video signal (average setting).
(peak setting) or the average value of the video signal (average setting).
DHCP (Dynamic Host Configuration Protocol)
Allows a server to dynamically assign
IP addresses to nodes (workstations) automatically. Provides client information including
subnetwork mask, gateway address, and DNS (Domain Address Server) addresses.
subnetwork mask, gateway address, and DNS (Domain Address Server) addresses.
DNR (Digital Noise Reduction)
Digital Noise Reduction eliminates the “flicker” that can
appear in an image under certain lighting conditions (for example, fluorescent lighting).
DSS (Digital Slow Shutter)
Automatically provides a clear image under low-light
conditions (increasing magnification may cause noise/distortion).
ELC (Electronic Light Control)
Typically used with manual iris lenses. The image
brightness is controlled electronically by the camera through automatically adjusting
shutter speed for a properly exposed picture.
shutter speed for a properly exposed picture.
Flickerless
Eliminates the “flicker” that can appear in an image under certain lighting
conditions (for example, fluorescent lighting). This is usually caused by the interaction of
the shutter with the AC frequency of the lighting. The flickerless setting changes the
camera shutter speed to a value that will not cause flicker (1/100 sec, NTSC, 1/120 sec
for PAL). The side effect is that the camera sensitivity is reduced because the electronic
iris feature has effectively been turned off and will no longer control the optimum exposure
setting for available light conditions.
the shutter with the AC frequency of the lighting. The flickerless setting changes the
camera shutter speed to a value that will not cause flicker (1/100 sec, NTSC, 1/120 sec
for PAL). The side effect is that the camera sensitivity is reduced because the electronic
iris feature has effectively been turned off and will no longer control the optimum exposure
setting for available light conditions.
FOV (Field of View)
The part of the scene visible with a particular lens. The height
(horizontal) and width (vertical) picture size at a given distance that can be seen through
a lens. Generally, shorter focal length lenses have a wider field of view than those with
longer focal lengths.
a lens. Generally, shorter focal length lenses have a wider field of view than those with
longer focal lengths.
Gain
The amplification a system provides to a signal.
IP Address
A unique, 32-bit identifier for a specific TCP/IP host computer on a network.
Iris Adjust
Adjusts the iris to either open or close in response to changing light
conditions.