Ryobi P500 User Manual

20

21

1

2

45

0

Fig. 24

Before performing any adjustment, make sure the bat-
tery pack is removed from tool and the switch is in the 
OFF position. Failure to heed this warning could result in 
serious personal injury.

See Figure 24.
The saw has a positive 0° bevel stop that has been factory 
adjusted to assure 0° angle of the saw blade when making 
90° cuts.

n

  Place  the  saw  in  an  upside  down  position  on  a  work-

bench.

n

  Check the squareness of the saw blade to the base of 

the saw using a carpenter’s square.

n

  Loosen bevel adjustment knob.

n

  Turn  setscrew  with  hex  key  and  adjust  base  until  it  is 

square with the saw blade.

n

  Tighten bevel adjustment knob securely.

Attempting  a  bevel  cut  without  having  the  bevel  ad-
justment knob securely tightened can result in serious 
injury.

See Figure 25.
�NOTE: Draw a pencil line on a scrap workpiece parallel to 
the long edge of the base as a straight line guide to aid in 
the adjusting process.
n

  Make sure the laser is turned off.

n

  Remove the laser cover by lifting it off its base.

�n  Turn the laser on.
�n  Loosen the screw inside the laser.
�n  Rest the front of the base on a scrap workpiece.
n

  Adjust  the  laser  beam  with  the  mark  on  the  scrap 

workpiece by loosening the screw to the laser aperture 

and slowly moving the laser guide left or right.

n

  Since blade thicknesses vary, always make a trial cut in 

scrap workpiece to ensure an accurate cut.

�n  Once alignment is achieved, tighten the screw.
�n  Replace the laser cover.
n

  Check for proper alignment.

�n  Repeat as necessary until the laser is aligned.

Fig. 25