Honeywell av8or User Manual

AV8OR User’s Guide                         Aviation Mode Operation  
VFR Moving Map Function 
 

Pub. No D200803000008         Page 3-16     Revision July 2008. 

© Honeywell International Inc. Do not copy without express permission of 

 The estimated time en-route data window displays the 

calculated time en route as the distance to the destination waypoint, 
divided by the ground speed.  If the ETE is greater then 10 minutes 
then the format is HH:MM.  If HH is less than 10 then no leading 
zeroes are displayed. Otherwise the format is MM:SS, with leading 
zeroes displayed.  If the ETE is invalid or greater than 24 hours then 
“--:--“ will be displayed. 
 
Examples are shown in the following table: 
 

1hr 55 min  

1

: 

55 

1min:55 sec  

01

: 

55 

24 min : 

 

24 

35 sec  

00

: 

35 

 

 The flight time data window displays the current flight 

duration in HH:MM format.  The flight timer displays the current time 
in flight or, if the flight has ended, the duration of the flight just ended.  
The flight timer begins counting when the ground speed exceeds 20 
knots.  The flight timer continues until the unit shuts down, or until 
the ground speed has been below 3 knots for 5 minutes.  If the 
ground speed exceeds 20 knots after the flight time had previously 
stopped then the flight time continues from the previous flight time. 

 The ground speed data window displays the current 

aircraft ground speed in the configured units.