ZyXEL Communications NWA3160 User Manual

Chapter 17 Log Screens

ZyXEL NWA-3160 Series User’s Guide

Go to the command interpreter interface (the Command Interpreter appendix explains how to access and 

use the commands).

Use the sys logs load command to load the log setting buffer that allows you to configure which logs 

the ZyXEL Device is to record.
Use sys logs category followed by a log category and a parameter to decide what to record 

Use the sys logs save command to store the settings in the ZyXEL Device (you must do this in order 

to record logs).

Use the sys logs display command to show all of the logs in the ZyXEL Device’s log.
Use the sys logs category display command to show the log settings for all of the log categories.
Use the sys logs display [log category] command to show the logs in an individual ZyXEL 

Device log category.
Use the sys logs clear command to erase all of the ZyXEL Device’s logs.

16

Information Reply

0

Information reply message

Table 82   Sys log

Mon dd hr:mm:ss hostname 
src="<srcIP:srcPort>" 
dst="<dstIP:dstPort>" 
msg="<msg>" note="<note>"

This message is sent by the "RAS" when this syslog is 

generated. The messages and notes are defined in this 

appendix’s other charts.

Table 81   ICMP Notes (continued)

Table 83   Log Categories and Available Settings

error

0, 1, 2, 3

mten

0, 1

Use 

0

 to not record logs for that category, 

1

 to record only logs for that category, 

2

 to record only 

alerts for that category, and 

3

 to record both logs and alerts for that category.