ZyXEL Communications NWA3160 User Manual

 Appendix E Text File Based Auto Configuration

ZyXEL NWA-3160 Series User’s Guide

You can use SNMP management software to display the configuration file version currently 
on the device by using the following MIB.

If you have any difficulties with the configuration file upload, you can try using the following 
MIB 10 to 20 seconds after using SNMP to have the AP download the configuration file.

The text based configuration file must use the following format.

Figure 194   Configuration File Format

The first line must be 

!#ZYXEL PROWLAN.

 

The second line must specify the file version. The AP compares the file version with the 
version of the last configuration file that it downloaded. If the version of the downloaded file is 
the same or smaller (older), the AP ignores the file. If the version of the downloaded file is 
larger (newer), the AP uses the file.

You can only use the 

wlan

 and 

wcfg

 commands in the configuration file. The AP ignores 

other ZyNOS commands but continues to check the next command.
The AP ignores any improperly formatted commands and continues to check the next line.

Step 3

pwTftpFileType

Set to 3 (text configuration file).

Step 4

pwTftpOpCommand

Set to 2 (download).

Table 118   Configuration via SNMP

Table 119   Displaying the File Version

pwCfgVersion

1.3.6.1.4.1.890.1.9.1.2

This displays the current configuration file version.

Table 120   Displaying the File Version

pwTftpOpStatus

1.3.6.1.4.1.890.1.9.1.6

This displays the current operating status of the TFTP 

client.

!#ZYXEL PROWLAN
!#VERSION 12
wcfg security 1 xxx
wcfg security save
wcfg ssid 1 xxx
wcfg ssid save