Kenwood TK-7102H User Manual

TK-7102H

User mode

PC mode

Data program-
ming mode

PC test mode

PC tuning mode

Clone mode

User mode

For normal use.

PC mode

Used for communication between the

radio and PC (IBM compatible).

Data programming

Used to read and write frequency data

mode

and other features to and from the radio.

PC test mode

Used to check the radio using the PC.

This feature is included in the FPU.

PC tuning mode

Used to tune the radio using the PC.

Clone mode

Used to transfer programming data from

one radio to another.

User mode

Power ON

PC mode

Received commands from PC

Clone mode

[1]+Power ON (Two seconds)

The TK-7102H transceiver is programmed using a per-

sonal computer, a programming interface (KPG-46) and pro-
gramming software (KPG-70D).

The programming software can be used with an IBM PC

or compatible.  Figure 1 shows the setup of an IBM PC for
programming.

1. Connect the TK-7102H to the personal computer with the

interface cable.

2. When the Power is switched on, user mode can be en-

tered immediately.  When the PC sends a command, the
radio enters PC mode.
When data is transmitted from transceiver, the red LED
blink.
When data is received by the transceiver, the green LED
blink.
In the PC mode, 4CH LEDs, [MON] LED and [

●] LED are

turned on.

• The data stored in the personal computer must match

model type when it is written into the EEPROM.

• Attach the interface cable, then change the TK-7102H to

PC mode.

The KPG-46 is required to interface the TK-7102H to the

computer.  It has a circuit in its D-subconnector (25-pin) case
that converts the RS-232C logic level to the TTL level.

The KPG-46 connects the modular microphone jack of the

TK-7102H to the computers RS-232C serial port.

The KPG-70D programming disk is supplied in 3-1/2" disk

format.  The software on this disk allows a user to program
TK-7102H radio via a programming interface cable (KPG-46).

If data is transferred to the transceiver from an IBM PC

with the KPG-70D, the destination data (basic radio informa-
tion) for each set can be modified.

IMC-PC

KPG-46

KPG-70D

TK-7102H