Fujitsu sparc m3000 User Manual

C120-E360-06EN

3-3

3.1  setrci

• OPERANDS

The following operands are supported:

• EXTENDED DESCRIPTION

z When "-c stat" is specified, the following states are displayed:

z When the RCI state is Active, the following information is displayed after List:

-c idpin

Displays the RCI address of the RCI I/O unit whose ID-PIN has been 
pressed.

-h

Displays usage statement. When used with other options or operands, an 
error occurs.

-s RCI_network

Specifies an RCI network. Either of the networks shown below can be 
specified for RCI_network. The specification must be made together with 
"-c init", "-c initconfig" and "-c addconfig".
RCI-0

Specifies the RCI network on the #0 side.

RCI-1

Specifies the RCI network on the #1 side

Specifies a target RCI address. A value in any of the following ranges can 
be specified for RCI_address:
003001ff-00307fff
007001ff-00707fff
002001ff-00207fff
006001ff-00607fff

RCI-x

RCI network name.

address

RCI address. It is displayed as an eight-digit hexadecimal number. When 
the RCI address of the host has not been set, the default value (00ff7fff) is 
displayed.

Active/Inactive

RCI state. Inactive means that the RCI is in the initial state, and Active 
means that the RCI setting has been made.
Inactive

The RCI is in the initial state.

Active

The RCI setting has been made.

Mainte

The mode switch is Service state.

address

The address of the connected RCI unit.

pwr

Power state of the RCI unit.
ON

Powered on.

OFF

Powered off.

alm

Alarm state of the RCI unit.
-

Normal state.

ALM

Alarm state.

WRN

Warning state.