Kenwood DDX370 User Manual

English

1

..........1

2

..........1 

(2m: 6.5 ft)

3

..........6

4

..........6

5

..........1

6 

*

1

..........2

7 

*

2

..........2

8 

*

2

..........1

9 

*

3

..........1 

(3m: 9.8 ft)

*

1

 

 

 DDX470/DDX4070BT/
DDX370/DDX3070 
only.

*

2 

   DDX790/DDX770/

DDX7070BT only.

*

3 

   DDX790/DDX770/

DDX7070BT/ DDX470/
DDX4070BT only.

1  To prevent a short circuit, remove the key 

from the ignition and disconnect the 

· 

battery.

2  Make the proper input and output wire 

connections for each unit.

3  Connect the speaker wires of the wiring 

harness.

4  Connect the wiring harness wires in the 

following order: ground, battery, ignition.

5  Connect the wiring harness connector to 

the unit.

6  Install the unit in your car.
7  Reconnect the 

· battery.

8  Press the reset button.
9  Perform the Initial Setup.

•  If you connect the ignition wire (red) and the 

battery wire (yellow) to the car chassis (ground), 
you may cause a short circuit, that in turn may 
start a fire. Always connect those wires to the 
power source running through the fuse box.

•  Do not cut out the fuse from the ignition wire 

(red) and the battery wire (yellow). The power 
supply must be connected to the wires via the 
fuse.

¤

•  Mounting and wiring this product requires 

skills and experience. For best safety, leave the 
mounting and wiring work to professionals.

•  Make sure to ground the unit to a negative 12V 

DC power supply.

•  Do not install the unit in a spot exposed to direct 

sunlight or excessive heat or humidity. Also avoid 
places with too much dust or the possibility of 
water splashing.

•  Do not use your own screws. Use only the screws 

provided. If you use the wrong screws, you could 
damage the unit.

•  If the power is not turned ON (“Miswiring 

DC Offset Error”, “Warning DC Offset Error” is 
displayed), the speaker wire may have a short-
circuit or touched the chassis of the vehicle and 
the protection function may have been activated. 
Therefore, the speaker wire should be checked.

•  If your car’s ignition does not have an ACC 

position, connect the ignition wires to a power 
source that can be turned on and off with the 
ignition key. If you connect the ignition wire to 
a power source with a constant voltage supply, 
such as with battery wires, the battery may be 
drained.

•  Only for DDX790/DDX770/DDX7070BT: If the 

console has a lid, make sure to install the unit so 
that the faceplate will not hit the lid when closing 
and opening.

EN_GET0907-001A_KR.indb   79

12/11/13   10:14