Crestron cen-oem User Manual

Ethernet OEM Module 

 

Crestron eServer™

These commands (dir, del, xputfile, free, initialize, and type) are available for 
executing file system commands. There is no need to use these commands via the 
setup menus since they are duplicated in Crestron software tools.  

These commands (forth, newSIMPL, pause, and resume) are available for executing 
SIMPL+ commands. There is no need to use these commands via the setup menus 
since they are duplicated in SIMPL+.  

 

To implement the eServer in a Crestron CNX control system, use a SIMPL Windows 
program (drop the CEN-OEM definition from the Ethernet Devices folder in 
Configuration Manager). The eServer definition can be found in the Ethernet Control 
Modules folder in the Device Library. The CEN-OEM, like any other device that is 
controlled via Ethernet from a Crestron control system, gets an IP ID and an entry in 
the IP Table of the control system. Refer to "ip_adr" on page 15 for setting the CEN-
OEM IP ID. For details about the IP Table, refer to "Add_master" on page 14. 

Use of the CEN-OEM symbol is necessary to incorporate the eServer functionality in 
a Crestron CNX control system. The SIMPL+ program or module that complements 
the SIMPL Windows program with eServer symbol is necessary to program the 
eServer itself.  

The interface to the CEN-OEM symbol in Program Manager looks like the symbol 
for a touchpanel. There are digital input/output lists, analog input/output lists, and 
serial input/output lists. The figure after this paragraph illustrates the CEN-OEM 
digital symbol as it appears in the Detail View of Program Manager.  

 

The following table shows how the SIMPL+ program inside the CEN-OEM 
interprets data routed into and out of the symbol.  

•  Ethernet OEM Module: eServer™