Fagor nc-200 pb Installation Instruction
Page: 28 - Installation Manual - NC-200 PB
2.4.3 Y AXIS HOME SEARCH. MODEL "B"
Usually, this axis has home switches on UP-STROKE models.
· Position the table or the ram at the far-end position activating the limit switch
I13.
· Press
. The
led turns on.
· Select the
axis. It displays the word "START".
· Press
to reach the home position.
· Actuate on the "BEND" footswitch until the punch or the die (on up-stroke
models) goes to its final position.
a) With a linear encoder:
· Press
to synchronize the Y axis home value set in PAR10 with that
of its associated axis Y'.
b) With a linear potentiometer:
It requires two synchronization points for the value of the Y axis with the
position of the table in order to obtain the V/mm constant of the
potentiometer and set an initial reference value.
position of the table in order to obtain the V/mm constant of the
potentiometer and set an initial reference value.
1- Pressr
, it displays the value of the potentiometer cursor in volts.
It enables the MANUAL mode.
2- Press
3- Use
to move the Y axis to the far-end position towards Y-.
Activate the BEND footswitch again until the final position.
Press
again.
Quit by pressing