Nautilus lc User Manual

mechanical Service guide

6.0 - rEPLACEMENT oF WALKING DECK

Tools Needed:

• Phillips Screwdriver
• 1/2 inch Wrench

NOTE:Ifusingapowereddriver,itmustbeonthe

“LOWTORQUE”setting,otherwiseitwill
stripscrews.

6-1 Elevate the treadmill, turn off the power, and

unplug the power cord from the wall outlet.

6-2 Remove (4) Phillips head screws with a Phillips

screwdriver from the inside, lower upright plastic
cover and (4) Phillips head screws from the outer
right side plastic cover. Remove the right side
plastic cover (see Figure 1).

6-3 Repeat Step 6-2 on the left side.

6-4 Remove the motor cover (see Figure 2).

6-5 Loosen the motor tension bolt (see Figure 3) using

a 1/2 inch wrench and then loosen the (4) 1/2 inch
nuts and bolts (bolt heads located under the motor
pan) securing the motor base to the pan. This will
allow the motor to slide towards the belt.

6-6 Slide the drive belt off the pulley on the end of the

motor shaft.

7 ! 2 . ) . '

! 4 4 % . 4 ) / .

$ ! . ' % 2

)--%$)!4%

# ! 5 4 ) / .

AS LoNG AS ThE TrEADMILL IS PLuGGED INTo A
PoWErED ouTLET AND ThE TrEADMILL CIrCuIT
BrEAKEr IS oN, ThE uNIT IS rECEIVING PoWEr,
EVEN IF ThE DISPLAY IS TurNED oFF. ALWAYS
uNPLuG ThE PoWEr CorD FroM ThE ouTLET
AND TrEADMILL WhEN PErForMING rEPAIrS or
MAINTENANCE.

Figure 1:

Figure 2:

Figure 3: