Casio fxcp400 fxcp400 User Manual

Chapter 15: Performing Data Communication

  258

You can connect the ClassPad to a CASIO projector and project ClassPad screen contents onto a screen. 
For information about connectable projectors, visit the site below. 
http://edu.casio.com/support/projector/

Some projector models may require a firmware update in order to project ClassPad screen contents. Before 
doing anything, go to the website above and check if your projector model requires updating.

1. Turn off the ClassPad.

2. Connect one end of the special cable that comes with 

the ClassPad to the USB port of your projector.

3. Connect the other end of the special cable as shown 

nearby. 

• ClassPad will turn on automatically and the Select 

Connection Mode screen will appear.

4. Tap [Projector].

5. On the dialog box that appears, tap [OK]. 

• An hourglass figure may remain projected on the screen after you connect the ClassPad to a projector. Also, 

changing to another screen while a graph is being drawn or while a program is running could possibly result in 
the projected screen being different from the ClassPad screen. If this happens, performing some operation on 
the ClassPad will restore normal display.

• If the ClassPad stops operating normally, disconnect the USB cable and then reconnect it. If this does not 

correct the problem, disconnect the USB cable, turn the projector off and then back on, and then reconnect 
the USB cable.