Compustar r500a User Manual
Remote Coding Procedure
5
6
The remote must be coded to the system installed in the vehicle before it
can be operated in any way. Listed below is the remote coding
procedure, please read through the directions before beginning.
can be operated in any way. Listed below is the remote coding
procedure, please read through the directions before beginning.
Step 1 : Turn the ignition ON then OFF, five times within seven seconds.
The parking lights on the vehicle should flash once.
Step 2 : Tap the button once.
The parking lights on the vehicle should flash once.
Step 3 : Repeat step 2 for each additional remote you have.
You can only program up to three remotes.
Step 4 : Wait a few seconds.
The parking lights on the vehicle should flash twice.
If you programmed three remotes, the
If you programmed three remotes, the
lights will flash twice right
away without waiting a few seconds.
To arm the alarm, hold the button down until the LED on the remote stops
flashing. To disarm the alarm, hold the button down until the LED on the
remote stops flashing. In either case, if the LED on the remote stops flashing
and the operation was not performed, you will need to release the button and try
again. These operations will lock and unlock the doors as well.
flashing. To disarm the alarm, hold the button down until the LED on the
remote stops flashing. In either case, if the LED on the remote stops flashing
and the operation was not performed, you will need to release the button and try
again. These operations will lock and unlock the doors as well.
Arming and Disarming the System
To release the trunk, hold the button down until the LED on the remote
stops flashing. If the LED on the remote stops flashing and the operation was
not performed, you will need to release the button and try again.
stops flashing. If the LED on the remote stops flashing and the operation was
not performed, you will need to release the button and try again.
Trunk Release
To lock the vehicle doors, hold the button down until the LED on the
remote stops flashing. To unlock the doors, hold the button down until
the LED on the remote stops flashing. In either case, if the LED on the
remote stops flashing and the operation was not performed, you will need
to release the button and try again.
remote stops flashing. To unlock the doors, hold the button down until
the LED on the remote stops flashing. In either case, if the LED on the
remote stops flashing and the operation was not performed, you will need
to release the button and try again.
Locking and Unlocking the Doors
Panic mode is to be activated when you are in trouble, or when you otherwise
want to call attention to your vehicle. Once panic mode is activated, the doors
will lock, the system will arm, and the siren will begin to sound. At this time the
parking lights will be flashing as well. To activate panic mode, hold the
want to call attention to your vehicle. Once panic mode is activated, the doors
will lock, the system will arm, and the siren will begin to sound. At this time the
parking lights will be flashing as well. To activate panic mode, hold the
button down for at least 2.5 seconds.
Panic Mode