Compustar p2bshledr User Manual

When servicing or loaning your vehicle to others, the CompuStar Pro system should be placed in Valet 
mode.  Valet mode prevents the system from remote starting and disables all alarm functions.        
IMPORTANT:  While in Valet mode the CompuStar Pro will still lock and unlock power lock systems.   

1.  Turn the vehicles key to the ignition “on” position and tap lock/unlock and key/start buttons 

simultaneously for 0.5 seconds. The parking lights will flash once and the remote will beep and 
LED flash once to confirm the system is in valet mode. Repeat this process to take the system 
out of valet mode. The parking lights will flash twice and remote will beep twice and LED flash 
twice to confirm the system is out of valet mode. 

 
2.  You can put the system into valet by turning the ignition key “on” and then “off” five 

times within 7 seconds. The parking lights will flash once to confirm the system is in 
valet mode. Shortly after the first flash, the parking lights will flash twice.   

 
3.  (Optional Feature) If your system is set up for a secure valet option, you will not be able to put the 

system into valet until the proper code has been entered with the secure valet switch. 

The only regular maintenance this system requires is remote control battery replacement.    
No programming is required when replacing the battery.  

First, remove the two small screw covers and Phillips screws located on the back of the remote.  Once 
the screws have been removed, gently pull the remote apart being careful to not touch the circuit board. 
The P2BSHLEDR requires two CR2025 batteries. These specialty batteries can be purchased from your 
local CompuStar dealer or an electronics store. 
 

 

Button 

Duration 

Additional 

Programming 

Required 

Function / Description 

0.5 
seconds 

no 

Lock/Arm. Tap again to Unlock/Disarm the vehicle 

 

2.5 
seconds 

no 

Trunk pop. Triggers the trunk release output and opens the 
vehicles trunk. 

0.5 
seconds 

yes, POC 

programming 

Aux 1. Triggers the auxiliary 1 output (most commonly used for 
rear defrost or window roll-down). 

 

2.5 
seconds 

no 

Activates the remote start. Repeat and remote start will shut off. 

0.5 
seconds 

no 

Valet mode (see above for details) 

 

 

 

2.5 
seconds 

no 

Panic mode. Honks horn and flashes parking lights. (Optional) 

  

 

4