Compustar p2bshledr User Manual

  
IMPORTANT: Every CompuStar Pro remote must be coded to the system prior to performing any 
operations. All remotes must be coded at the same time. 

IMPORTANT: Every CompuStar Pro remote must be coded to the system prior to performing any 
operations. All remotes must be coded at the same time. 

 
STEP 1: Activate Valet/Programming mode by manually turning the ignition key on and off (between the 
Acc & On positions) five times within 7 seconds. The vehicle’s parking lights will flash once with the 
successful completion of this step. 
 
STEP 2: Within a 3 second period after cycling the ignition for the 5

th

 time, pressing the single button 

once for 0.5 seconds. The parking lights will flash once to confirm the transmitter has been coded. 

 
Exiting Programming: Programming is a timed sequence.  The 
parking lights will flash twice signaling the end of programming mode. 
 
Programming Multiple Remotes: After the confirmation flash given in 
step 2, code additional remotes by pressing the single button

 

on 

remote. The parking lights will flash once confirming each additional 
remote. All systems can recognize up to three remotes. 
 
 
 
 

 
If the remote start fails to start the vehicle, the parking lights will flash three times immediately. Following 
those three flashes the parking lights will flash again corresponding to the error table.   
 

1 Motor 

running 

2 

Key in ignition on position 

3 

Door open (manual transmission only) 

4 Trunk 

open 

5 

Foot brake on 

6 Hood 

open 

7 

Reservation off (manual transmission only) 

8 

Tach or voltage sensing failure 

 
We recommend that you do not attempt any repairs on your remote starter. Contact your dealer or call us 
directly. 
 
 
 
 
 
 

  

 

8