Bay Technical Associates BayTech DS72 User Manual

DS72 Host Module 

 

8

22. Select the ‘Gateway Address’ option and type the assigned Gateway address and press 

‘Enter’. 

23. Press ‘Enter’ until you are asked to ‘Accept Changes’. Type ‘Y’ to accept changes. 
24. Press ‘Enter’ until you get the Network Access Menu, (Figure 1). 
25. Select ‘Unit reset’ to update the external connections. Once the reset is completed (1 minute) 

connect the Baytech device to your network using an Ethernet cable. 

 
At this point you have setup enough basic configurations to operate this Baytech unit. 

 

•  Connect the 9FRJ45PC-4 adapter to the user’s computer  

•  Connect the Host Module’s EIA-232 port to the adapter via the RJ08X007 rolled flat ribbon 

cable.  

•  Default configuration is 9600 bps, 8 data bits, 1 stop bit and no parity. 

 

NOTE:  At any time during the session you need to go to another menu, use the Attention 
Character = semi-colon (;).  Press the attention character key 5 consecutive times to get back to 
the main status menu.  

 

NOTE: Depending on the DS-Series model, the menus will vary according to the number of DS74 
modules installed in the unit. If this is not an initial set-up and Password has already been enabled, 
you are prompted to login. After logging in successfully, invoke the main menu by sending the 
attention character five times (;;;;;). 

 

NOTE: Password feature is case sensitive. (Default is user/password is root/baytech) 

The following Menu appears or similar: 
 
Figure 1 

 

 

 
Select option ‘C’ for the configuration menu. Select the DS72 module option and the following menu 
is displayed: