ZyXEL Communications PLA-407 User Manual

 Chapter 4 The ENCRYPT Button

PLA-407 User’s Guide

If you want to add more Powerline devices to your network after the initial setup 
(refer to 

), do the following.

To add more Powerline devices to your network, press the ENCRYPT button on 
device C (shown below) for more than 10 seconds until the power (

) light 

flashes. 

Then repeat steps 

 and 

 in the previous section using any Powerline device (A or 

B) you have connected using ENCRYPT and the Powerline device you want to 
connect (C). You must use the ENCRYPT button on both devices.

Figure 11   Adding More Powerline Adapters to Your Network 

If you have previously disconnected your computer or modem (or any other 
networking product connected to your Powerline device), you can now reconnect 
them.

This sets up your Powerline network between your Powerline devices. 

You can use the ENCRYPT button to set up multiple Powerline networks using 
your existing Powerline network.