ZyXEL Communications PLA-407 User Manual
Chapter 7 Powerline Network Setup Tutorial
PLA-407 User’s Guide
69
5
The settings for the adapter will now grey out and the adapter will disappear from
the table after a few minutes.
the table after a few minutes.
Figure 48 An Adapter on Your New Network
6
Go back to step
in this section to set the same, new Network Name for all
remote adapters you want to add to your new network.
7
Check you have added the adapters correctly by changing the network name for
the local adapter. All adapters with the new Network Name now appear in the
list of adapters on your network. These adapters are now part of your new
network.
the local adapter. All adapters with the new Network Name now appear in the
list of adapters on your network. These adapters are now part of your new
network.
Figure 49 Adapters on a New Powerline Network
• If you want to access any of your new Powerline networks using the PLA-4xx
Series Configuration Utility, change the Network Name on your local
adapter to the network name for the network you want to access. The adapters
on that network will then display in the adapter table, allowing you to select and
configure each one.