Zebra Technologies P330i User Manual
Installation and Setup
Setting the Card Thickness Control
980459-001 Rev. A
P330i User’s Manual
17
3.
There are four detents to set the position of the Card Thickness Control. Slide the Card
Thickness Control to the position corresponding to the following:
Thickness Control to the position corresponding to the following:
Detent Position Card Thickness
Highest
50 mil (1.27 mm) to 60 mil (1.52 mm)
3rd position
30 mil (0.76 mm) to 50 mil (1.27 mm)
2nd position
20 mil (0.51 mm) to 40 mil (1.02 mm)
Lowest
10 mil (0.25 mm) to 20 mil (0.51 mm)
Card Thickness
Control
Control
Note •
The overlap in settings above accomodates variations in environmental conditions
(especially humidity) and cards from different manufacturers. In general, start at the lowest
position and move the lever up until cards feed reliably.
position and move the lever up until cards feed reliably.
Note •
“60 mil” (“1.524 mm”) cards may have a significant variation (over 10%) in the
actual thickness of the cards; do not use these cards unless each card has been measured to
have a thickness less than 66 mil (1.676 mm).
have a thickness less than 66 mil (1.676 mm).