ZyXEL Communications zywall 50 User Manual
ZyWALL 50 Internet Security Gateway
18-6
Firmware and Configuration File Maintenance
TFTP [-i] host get rom-0 config.rom
where “i” specifies binary image transfer mode (use this mode when transferring binary files), “host” is the
ZyWALL IP address, “get” transfers the file source on the ZyWALL (rom-0 name of the configuration file
on the ZyWALL) to the file destination on the computer and renames it config.rom.
ZyWALL IP address, “get” transfers the file source on the ZyWALL (rom-0 name of the configuration file
on the ZyWALL) to the file destination on the computer and renames it config.rom.
18.2.8 GUI-Based TFTP Clients
The following table describes some of the fields that you may see in GUI-Based TFTP clients.
Table 18-3 General Commands for GUI-Based TFTP Clients
COMMAND DESCRIPTION
Host
Enter the IP address of the ZyWALL. 192.168.1.1 is the ZyWALL’s default IP address
when shipped.
when shipped.
Send/Fetch
Use “Send” to upload the file to the ZyWALL and “Fetch” to back up the file on your
computer.
computer.
Local File
Enter the path and name of the firmware file (*.bin extension) or configuration file
(*.rom extension) on your computer.
(*.rom extension) on your computer.
Remote File
This is the filename on the ZyWALL. The filename for the firmware is “ras” and for the
configuration file, is “rom-0”.
configuration file, is “rom-0”.
Binary
Transfer the file in binary mode.
Abort
Stop transfer of the file.
Refer to section 18.2.5 to read about configurations that disallow TFTP and FTP over WAN.
18.2.9 Backup Via Console Port
Backup configuration via console port by following the HyperTerminal procedure shown next. Procedures
using other serial communications programs should be similar.
using other serial communications programs should be similar.
Step 1. Display menu 24.5 and enter “y” at the following screen.
Figure 18-3 System Maintenance — Backup Configuration
Ready to backup Configuration via Xmodem.
Do you want to continue (y/n):
Do you want to continue (y/n):