ZyXEL Communications ZYWALL10 User Manual

ZyWALL 10 Internet Security Gateway

3-8

Internet Access

Use the instructions in the following table to configure IP Alias parameters.

IP Alias

Choose Yes to configure the LAN network for the ZyWALL.

IP Address

Enter the IP address of your ZyWALL in dotted decimal notation

192.168.2.1

IP Subnet Mask Your ZyWALL will automatically calculate the subnet mask based on

the IP address that you assign. Unless you are implementing
subnetting, use the subnet mask computed by the ZyWALL

255.255.255.0

RIP Direction

Press the [SPACE BAR] to select the RIP direction from Both, In
Only, Out Only or None.

Version

Press the [SPACE BAR] to select the RIP version from RIP-1, RIP-
2B or RIP-2M.

Incoming
Protocol Filters

Enter the filter set(s) you wish to apply to the incoming traffic
between this node and the ZyWALL.

1

Outgoing
Protocol Filters

Enter the filter set(s) you wish to apply to the outgoing traffic between
this node and the ZyWALL.

2

When you have completed this menu, press [ENTER] at the prompt [Press ENTER to Confirm…] to save
your configuration, or press [ESC] at any time to cancel.

You will see three different menu 4 screens depending on whether you chose Ethernet, PPTP or PPPoE
Encapsulation.

You must choose the Ethernet option when the WAN port is used as a regular Ethernet. The PPPoE choice
is for a dial-up connection using PPPoE.  If you choose Ethernet in menu 4 you will see the next screen.