ZyXEL Communications ZYWALL10 User Manual

ZyWALL 10 Internet Security Gateway

4-6

Remote Node Setup

Move the cursor to the Edit IP field in menu 11.1, then press the [SPACE BAR] to toggle and set the value
to Yes.  Press [ENTER]

 

to open Menu 11.3 - Network Layer Options.

The next table gives you instructions about configuring remote node network layer options.

IP Address
Assignment

If your ISP did not assign you an explicit IP address, select
Dynamic; otherwise select Static and enter the IP address & subnet
mask in the following fields.

IP Address

If you have a Static IP Assignment, enter the IP address assigned to
you by your ISP.

IP Subnet
Mask

If you have a Static IP Assignment, enter the subnet mask assigned
to you.

Gateway IP
Addr

If you have a Static IP Assignment, enter the gateway IP address
assigned to you.

Network
Address
Translation

Use the [SPACE BAR] to select either Full Feature, None or SUA
Only. See the NAT chapter for a full discussion on this feature.

Metric

This field is valid only for PPTP/PPPoE encapsulation. The metric
represents the “cost” of transmission for routing purposes. IP routing
uses hop count as the measurement of cost, with a minimum of 1 for
directly connected networks. Enter a number that approximates the
cost for this link. The number need not be precise, but it must be
between 1 and 15. In practice, 2 or 3 is usually a good number.

3

Menu 11.3 - Remote Node Network Layer Options

                    IP Address Assignment= Dynamic
                    IP Address= N/A
                    IP Subnet Mask= N/A
                    Gateway IP Addr= N/A

   Network Address Translation= SUA Only

                    Metric= N/A
                    Private= N/A
                    RIP Direction= None
                      Version= N/A
                    Multicast= None

                     Enter here to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle