Kenwood fleetsync tk-690 User Manual

15

■

Press the POWER switch to switch the transceiver ON (or OFF)

• The display backlight illuminates when the power is switched ON.

■

Turn the VOL control clockwise to increase the volume, and counterclockwise
to decrease it.

■

Press the Group Up or Group Down keys, or use the CH control (depending
on which one is programmed with the group functions).

• Pressing Group Up or Group Down will increase or decrease the group selection.

• Turning the CH control clockwise will increase the group selection, and turning it

counterclockwise will decrease the selection.

■

Press the Channel Up or Channel Down keys, or use the CH control
(depending on which one is programmed with the channel functions).

• Pressing Channel Up or Channel Down will increase or decrease the channel

selection.

• Turning the CH control clockwise will increase the channel selection, and turning it

counterclockwise will decrease the selection.

■

1 Select the desired group and channel (above).

• Make sure the channel is not in use.  If the channel is in use, the BUSY (green)

indicator will light; wait until the channel is no longer in use.

2 Press the PTT switch, then speak into the microphone in your normal

speaking voice.

• For best results, hold the transceiver approximately 3 to 4 cm (1 1/2 inches)

from your lips.

3 Release the PTT switch to receive.

4 Replace the microphone on the hanger when the call is finished.