National Instruments 3.22E+04 User Manual

Index

© National Instruments Corporation

I-5

PCI Serial for Windows Me/9x

straight-through cabling in a DTE-to-DCE

interface (figure), A-7

successful uninstallation (figure), B-4
system integration, by National

Instruments, E-1

T

technical support resources, E-1
termination, A-5

multidrop network using terminating

resistors (figure), A-5

time-saving development tools, 1-4
transceiver control modes (table), 4-2
transceiver mode, 3-4

setting with DeviceloControl, 4-4

transceiver mode control bytes (table), 4-4
transmission line using bias resistors

troubleshooting, C-1

diagnostic messages, C-2
forcing Windows to detect your

freeing an interrupt request level, C-1
resolving resource conflicts with legacy

selecting conflict-free resources, C-2

two-port boards specifications, D-1

isolated two-port boards, D-1

two-wire devices, 2-15

connecting, 2-15

typical full-duplex system (figure), A-4
typical half-duplex system (figure), A-4

U

uninstalling serial hardware, B-1
uninstalling serial software, B-2
using FIFO buffers, 3-4
using serial hardware, 4-1
using this manual, 1-1

V

verifying hardware installation, 2-5
viewing or changing communication port

W

Web support from National Instruments, E-1
Win32 Overviews and Win32 Reference, 4-1
Win32 Software Development Kit, 4-1
worldwide technical support, E-2