Crestron tps-tpi User Manual

Touchpanel Interface 

 

Crestron Isys™ TPS-TPI

can vary from 0 to 120, where 0 disables the timeout. DOWN and UP buttons 
decrease and increase the timeout, respectively.  

Panel tracking is a useful communication feature between displays when more than 
one display exists on the network. Two buttons centrally located in the bottom row 
of the Setup Menu control panel tracking. Button selection is indicated by red text. 
When the Enable Panel Tracking button is selected, a given display maintains 
communication in such a way that a page change to any display on the network 
forces the same page change to all enabled displays. Panel tracking is disabled for a 
given display when the Disable Panel Tracking button is selected. When disabled a 
given display does not respond to page changes made to other displays on the 
network. Panel tracking is factory set with the Disable Panel Tracking button 
selected. 

NOTE:  The Ethernet button is displayed on the Setup Menu only if the  
TPS-ENETL is properly installed.  

NOTE:  IP settings are necessary only if the TPS-ENETL is installed. Serially 
connect a PC to the TPS-TPI via the RS-232 connector and refer to the details in the 
latest revision of the TPS-ENETL (Doc. 5829).  

Selection of the Ethernet button from the Setup Menu displays details such as the IP 
Address, Subnet Mask, Def(ault) Router, IP Table, etc. For example, refer to a 
sample display shown after this paragraph. The settings can only be viewed from this 
screen. To enter commands to access/set all Ethernet configurations use the RS-232 
connector and refer to the information in the TPS-ENETL Installation & Operations 
Guide, as stated in the previous note.  

 

Select the Return button, located at the lower right corner of the Setup Menu, after 
setup parameters have been set. 

The TPS-TPI communicates with a control system to activate other controls or to 
display feedback from components within the system. The communication interface 
must be correctly specified or communication will not occur. To set communication 

•  Touchpanel Interface: Crestron Isys™ TPS-TPI