D-Link voip ta dvg-5112s User Manual
DVG-5112S User’s Manual
D-Link Systems, Inc. 33
3-18 Line Settings
Listening Volume: Adjusts the earpiece or speaker volume.
Speaking Volume: Adjusts the microphone volume.
Tone Volume: Adds a new option to make tone volume adjustable. This setting will be applied to all
Speaking Volume: Adjusts the microphone volume.
Tone Volume: Adds a new option to make tone volume adjustable. This setting will be applied to all
tones generated by the gateway including dial tone and busy tone.
Min. FXS Hook Flash Time: It is to set the minimum flash time for FXS detecting.
Flash Time: Used to adjust the detection period for flash signals from a phone set connected to an
Flash Time: Used to adjust the detection period for flash signals from a phone set connected to an
FXS port. For example, if pressing the HOLD key sometimes disconnects a call, increasing the “Flash
Detect Time” should fix this issue.
Detect Time” should fix this issue.
Enable Polarity Reversal: As a remote site answers calls from this extension the FXS port will
reverse polarity.
FXS Chip Option 1: It is to avoid mis-detecting the loop state of a subscriber line or PBX user loop by
FXS interface. In some places, the voltage of off-hook makes it mis-detect the idle state and the active
state by FXS interface. Untick this variable if it mis-detects the state by FXS interface in your place.
state by FXS interface. Untick this variable if it mis-detects the state by FXS interface in your place.
Ring (Early Media) Time Limit[10 - 600secs]:The timeout to cancel a call when no one answers.
Enable End of Digit Tone:The gateway will play a “Beep-Beep” tone to notify that the call is in
Enable End of Digit Tone:The gateway will play a “Beep-Beep” tone to notify that the call is in
progress.
Early Media Treatment: If this variable is disabled, the system will send RTP immediately after a
connection with a proxy is set up. The default setting is enabled. If communicating with other gateways
encounters problems, please disable this function.
encounters problems, please disable this function.
Loop Current Drop Trigger Time: It is to set the trigger time for dropping loop current by FXS port. A
setting of zero is to disable this function. It is used to avoid the line engaged if FXS port is connected to
PBX.
PBX.
Loop Current Drop Duration: It is to set the drop duration.