Crestron qs sw-roomvw-svr User Manual
RoomView 7.0
Getting Started Guide
Installation/Configuration
Procedures
Procedures
These procedures assume that RoomView 7.0 has been
properly installed and configured on your system(s) and
that you will be connecting to a processor running the
demo program when you add a room as described in this
guide. For more information see the RoomView 7.0
Installation Guide (Doc. 6543).
properly installed and configured on your system(s) and
that you will be connecting to a processor running the
demo program when you add a room as described in this
guide. For more information see the RoomView 7.0
Installation Guide (Doc. 6543).
Adding a Room in RoomView
1. Log into RoomView and click the Setup tab at the
top of the main RoomView window.
5. Enter information into the fields indicated as required
by the red asterisk.
2. Click on the Tree View tab.
6. Enter the optional information, such as time zone, e-
Control and webcam urls, as desired.
7. Enter the processor details appropriate to your
installation as shown in the following figure.
3. Click on the folder, or tree node, where you want to
add the room.
NOTE: When adding a processor to an existing room via
Add Processor, the form shown above will also have
fields for Name and Location.
Add Processor, the form shown above will also have
fields for Name and Location.
8. Select the Symbol version and IPID. Note that the
demo program has a RoomView 6.0 symbol at IPID
03 and a RoomView 7.0 symbol at IPID 05.
03 and a RoomView 7.0 symbol at IPID 05.
4. Place the cursor on the Add menu and select Add
Typical Room when the menu drops down.
NOTE: When adding a new symbol to an existing
processor via Add Symbol, the form shown above will
also have a field for Symbol Name.
processor via Add Symbol, the form shown above will
also have a field for Symbol Name.
Getting Started Guide – DOC. 6544
Remote Asset Management Software : RoomView 7.0
• 1