Dynex DX-32L150A11 User Manual

32", 37", 40", and 46" LCD TV

DX-32L150A11, DX-37L150A11, DX-40L130A11, 
and DX-46L150A11 

HDMI cable 
(not included)

HDMI device

Video device

Composite

video cable

Video device

S-video cable

Remote control 

and 

2 AAA batteries

Component 

video cable

AC power cord

TV stand and screws

Component

video cable

Component video device

Back of TV

Back of TV

Back of TV

Back of TV

Back of TV

Back of TV

Back of TV

Antenna cable

Audio cable

Audio cable

Stand

Locating 
grooves

Locators

1   Remove the stand from the box and place it on a table or bench.

Note: Pay close attention to the direction of the stand. The wide portion of the stand must 
face the front of the TV.

2   Lay the TV on a flat, cushioned surface.
3   Align the stand with the TV, as shown.

4   Move the stand gently until the locators on the stand column align with the 

locating grooves on the stand.

5   Align the holes in the stand with the holes in the stand column.
6  Secure the stand to the column with the screws provided

1   Carefully place your TV screen face-down on a cushioned, clean surface to 

protect the screen from damages and scratches.

2   Remove the four screws holding the TV to its stand column, then remove the 

stand column.

3  Secure the wall-mount bracket (not included) to the back of your TV using the 

four M6 screws provided with the bracket.

1   While pressing the release button on the battery compartment cover on the 

back of the remote, lift the cover off the remote.

 

2   Insert two AAA batteries into the battery compartment. Make sure that the + 

and – symbols on the batteries align with the + and – symbols in the battery 
compartment.

3   Replace the cover.

To program your existing remote control to work with your Dynex TV, see the 
table below for common codes. If you have problems programming your 
remote, or need a different remote control code, visit www.dynexproducts.com 
for the latest remote control code information.

Connect a 75 ohm cable (not included) to ANT/CABLE IN jack on the back of 
your TV and the RF OUT jack on the antenna.

Note: Cable connectors and jacks are often color-coded. Match the colors when 
you connect the AV cable. 

Note: The DIGITAL OUTPUT jack only works with digital TV channels.

Remote control 

sensor

Power
indicator

(for all Dynex TVs manufactured after Jan. 1, 2007)

Philips

PHDVD5, PH5DSS,

PMDVR8, PDVR8

 

DirectTV

RC23

RCA

RCU807

One for All

URC-6690

Sony

RM-VL600

 

Comcast

M1057

 

Dish Network

VIP508, VIP622

 

Motorola

DRC800

 

TIVO

Series 3, HD