Clickfree c2n 3.5 User Manual

Clickfree C2N Home Backup (Mac) 

 

Frequently Asked Questions 

From time to time Clickfree software is upgraded to provide new or enhanced features.  

Clickfree automatically looks for updates when it is connected to your computer and you 
have a connection to the Internet.  

If you access the C2N over the network (using the BackupLink utility), updates are applied 
the next time you start a backup. 

To ensure automatic updates is enabled, make sure that the check box 

 is selected on the 

 window. To stop checking automatically for updates, 

clear this check box. 

To check for updates manually,  

1.  On the 

 window click 

 

. Clickfree checks for available updates. 

2.  If the software in your C2N and your computer is up to date, click 

 on the dialog that 

pops up. 

If an update is available, it is downloaded and your software is updated. 

While a software update is taking place, do not remove the C2N from your computer 

and do not turn off or restart the computer until the update is complete. 

3.  When the software update is complete, you must unplug the C2N and plug it in again 

for the update to take effect. 

 is used to remove all backed-up content from all computers that have been 

backed up on your C2N, and to apply factory settings. 

After you perform a 

 you can no longer restore any previously backed-up 

content, but your C2N can still be used for new backups. 

If you want to remove only the content that was backed up from one user, see “Removing a 
User” on page 20. 

1.  On the 

 window click 

. 

2.  You are prompted to confirm that you want to remove all backed-up content from 

Clickfree – select the check box and click 

. 

Once you have removed content from Clickfree using Master Reset there is no way to 

recover any backed-up content from the C2N. 

Clickfree may take several minutes to erase all of the content, depending on the amount of 
content backed up on the C2N. 

Copyright © 2010  Storage Appliance Corporation. 

23