Clarion HX-D2 User Manual

HX-D2

Power does not turn 
on. 
(No sound is pro-
duced.)

No sound output 
when operating the 
unit with amplifiers or 
power antenna attach-
ed.

Nothing happens 
when buttons are 
pressed.

Display is not accu-
rate.

Fuse is blown.

Incorrect wiring.

Power antenna lead is short-
ed to ground or excessive 
current is required for re-
mote controlling on the am-
plifiers or power antenna.

The microprocessor has 
malfunctioned due to noise, 
etc.

Compact disc cannot 
be loaded.

Sound skips or is 
noisy.

Sound is bad directly 
after power is turned 
on.

The CD is automati-
cally ejected.

Another compact disc is al-
ready loaded.

Compact disc is dirty.

Compact disc is heavily 
scratched or warped.

Water droplets may form on 
the internal lens when the 
car is parked in a humid 
place.

A CD is loaded upside-
down inside the CD deck 
and does not play.

Eject the compact disc before loading the new 
one.

Clean the compact disc with a soft cloth.

Replace with a compact disc with no scratches.

Let dry for about 1 hour with the power on.

Eject the disc then reload it properly.

Replace with a fuse of the same amperage. If 
the fuse blows again, consult your store of 
purchase. 

Consult your store of purchase.

1. Turn the unit off.
2. Remove all wires attached to the power 

antenna lead. Check each wire for a possible 
short to ground using an ohm meter.

3. Turn the unit back on.
4. Reconnect each amplifier remote wire to  the 

power antenna lead one by one. If the 
amplifiers turn off before all wires are attached, 
use an external relay to provide 
remote-on voltage (excessive current required).

Press the reset button for 
about 2 seconds with a 
thin rod.

Reset button