Intermatic 158wf12660ref User Manual

WF401

GENERAL INSTRUCTIONS FOR WATERFALL USE

1. Unpack the product, wipe off dust with a damp cloth. Take out all

accessories: pump and adapter. Spare bulb included.

2. Familiarize yourself with the pump. The switch located at the front of it controls

the water flow. The flow is indicated by a max and min sign. To increase flow,

move switch in the direction of max. To decrease flow, move the switch toward

min.

CAUTION: This pump has been evaluated for use with water only.

NOTE: It is recommended the pump be set at its highest flow during assembly

and later adjusted to a lower setting if desired. Be sure to unplug pump before

adjusting flow setting.

WARNING

: RISK OF ELECTRICAL SHOCK

• Do not connect to any voltage other than that shown on the pump.

• This pump is supplied with a grounding conductor and grounding-type attach-

ment plug. To reduce the risk of electric shock, be certain that it is connected

only to a properly grounded, grounding-type receptacle.

• The national electric code requires that a ground fault circuit interrupter (GFCI)

be used in the branch circuit supplying fountain pumps and other pond

equipment. See your electrical supplies dealer for this device.

• If the supply cable is damaged it can not be replaced and the pump unit should

be discarded.

WARNING

: RISK OF FIRE

• Do not use with water above 30˚C.

• Do not pump flammable liquids.

3. Attach the pump to the connector tube on the fountain and place the pump inside

the fountain. Take the lamp and feed from the back of the fountain through the hole in the front and snap into clip.

WARNING:

Ensure that the plastic cap housing the light for protection is taken off the bulb before plugging into outlet.

Failure to do so will result in melting the cap and potentially damaging the light.

Attach the AC adapter jack to the base power cord. Both the wires from the pump and the

light should run through the notch on the back of the fountain. Connect the cable for light

to that AC adapter and tighten.

INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS

IMPORTANT SAFETY INSTRUCTIONS

LIGHTED LAMP IS HOT!

WARNING: TO REDUCE THE RISK OF FIRE OR INJURY TO PERSONS:

• Turn off/unplug and allow to cool before replacing lamp.

• Lamp gets HOT quickly! Contact only switch/plug when

turning on.

• Keep lamp away from materials that may burn.

• Do not touch the lamp at any time.

Use a soft cloth. Oil from skin may damage lamp.

• Do not operate the luminaire fitting with a missing or

damaged shield.

• Do not touch hot lens.

NOTE: Do not let pump run when NOT submerged in water. Doing so may damage the pump. Always submerge

the pump in water first, and then plug in the unit.
4. Fill base with distilled water to approximately 1/2" above pump. Use distilled water only. Tapwater will create mineral

deposits that will result in the corruption of the Waterfall and pump.

NOTICE: Do not place outdoors in weather conditions below 32˚F, may cause water to freeze.
5. Plug cord into 120V household outlet. Turn pump on to verify flow making sure it is not too high and everything is

operating correctly. Arrange river rocks on top of plate.

WARNING: This is not a toy. Keep out of reach of Children and Pets.
NOTE: Ensure that the electrical cord loop below the electrical outlet.” This will prevent water from running down

the cord into the electrical outlet.

10W