Clifford remote start & security system 520.4x User Manual

10

© 2011 Directed Electronics. All rights reserved.

Basic Commands (Direct Access)

No Ghost LED’s on

Arm

Press and release 

The alarm arms, doors lock (if connected), and the siren chirps and 
parking lights flash once. The Arm LED and beeps play to confirm. If 
Valet mode* is On, the doors lock and the Arm LED, 

LED and a 

fault tone plays. Exit Valet mode to arm the alarm normally.

If a trigger zone fault is detected the siren chirps once again and the 
remote will emit a Trigger Zone Fault Report**, the Arm LED, 

LED 

and a fault tone plays. 

To Arm and Panic

Press and hold 

 

The alarm Arms (or Locks in Valet) and, after 2 seconds, sounds 
the siren and flashes the parking lights. The ghost LED’s flash and 
siren tones play to confirm. Press the 

or

 button to stop the 

output. 

Disarm

Press and release 

The alarm disarms, doors unlock (if connected), and the siren chirps 
and parking lights flash twice. The Disarm LED and beeps play to 
confirm. If Valet mode* is On, the doors unlock and the Disarm LED,   

LED and fault tones play.

An Alarm Report** will replace the disarm output if the alarm was