Clifford remote start & security system 520.4x User Manual

Page of 53
31
© 2011 Directed Electronics. All rights reserved.
Note
Temperature report must be turned on by an authorized Di-
rected dealer.
Remote Start Time-out Alert
During remote start a message is sent three minutes before and again 
at one minute before the engine turns off. The 
LED, Remote Start 
LED flash and several tones play as an alert to reset the runtime if 
desired.
Manual Transmission Start (MTS mode)
When installed into a manual transmission vehicle, the system requires 
that the MTS mode is properly set when parking. If MTS mode is not 
properly set or is defeated after being properly set the system will not 
start the engine.
1.  With the engine running, set the parking brake and leave the 
engine running. For Pit Stop or Turbo Timer mode (to leave the 
engine running after arming), open the driver door.
2.  Release the foot brake (if pressed during Step 1), or press and 
release the foot brake anytime. As long as the engine is running 
there is no time limit to perform this step.
3.  Within 20 seconds of foot brake release, press any command 
button on the remote, after 20 seconds return to Step 2 (For Turbo 
Timer Mode, press the optional dash mounted activation button 
or send the Timer Mode command.
4.  The parking lights flash 5 times to confirm MTS mode enable and 
the remote start activates the ignition outputs. The Remote Start 
LED and On tones play to confirm.
5.  Turn Off and remove the key from the ignition switch, the engine 
remains running.
6.  Exit the vehicle, close all the doors and arm the system.